MATLAB: Simulink Test Test Manager: create baseline for only subset of simulation time.

simulink test

 Is it possible to capture a "baseline criteria" in the Test Manager and check for compliance only during a specific instance/section in time rather than the full simulation time? I.e. a baseline for only a subset of the simulation.

Best Answer

Currently this is not possible with the Test Manager using a method similar to that shown in the link below.
https://www.mathworks.com/help/releases/R2019a/sltest/examples/creating-baseline-tests.html
As an alternative consider using the Test Sequence block to test a certain section of your simulation.
https://www.mathworks.com/help/releases/R2019a/sltest/ug/introduction-to-test-sequences.html
Another alternative would be to use Operating Point (SimStates prior to R2019a) to save the model states at a particular time and then you can run a simulation starting from that state, so basically the test harness only runs the section of time that you want.
https://www.mathworks.com/help/releases/R2019a/simulink/ug/saving-and-restoring-simulation-operating-point.html
In R2019a you can also create Temporal Assessments which may or may not be relevant to you based on your application.
https://www.mathworks.com/help/releases/R2019a/sltest/ug/temporal-assessments.html
Related Question