After installing 2016a, I noticed when creating new figure, the top part of the figure is little off the top screen/monitor edge. The menu bar is not showing, due to wrong position
I have to shake the window with the mouse a little to be able to see the top banner of the window (where the word "figure" is) and then drag the window down and resize it to make it little smaller so I can see the full figure window.
Is someone else having this problem also?
I simply do
figure
The figure window also is physically much larger than it shows with Matlab 2015a on same PC. It seems to be almost twice as large.
This is Matlab 2016a on windows 7, 64 bit.
Is there a way to correct this? It is very annoying having to adjust the figure window each time.
–Nasser
Best Answer