MATLAB: Is there a patch available for Simulink 5.0 (R13), Real-Time Workshop 5.0 (R13), or any of the R13 blocksets and toolboxes

simulink

I would like to know if there is a patch available for Simulink 5.0 (R13), Real-Time Workshop 5.0 (R13), or any of the R13 blocksets and toolboxes.

Best Answer

There are no available patches for Simulink 5.0 (R13), Real-Time Workshop 5.0 (R13), or any of the R13 blocksets and toolboxes.

Related Solutions

MATLAB: Is the Control System Toolbox 7.1 (R2006b) compatible with Real-Time Workshop 6.5 (R2006b)

This bug has been fixed in Release 2007b (R2007b). For previous product releases, read below for any possible workarounds:

Documentation for Real-Time Workshop 6.5 (R2006b) is missing from the Real-Time Workshop section that lists the supported products.

Here is additional information on Real-Time Workshop:

The Control System Toolbox block, LTI Subsystem, is compatible with code generation.

MATLAB: Is the documentation on deletion of user *.c files from the ‘rtw’ build directory unclear in the Real-Time Workshop 5.0 (R13)

This bug has been fixed in Release 14 Service Pack 2 (R14SP2). For previous releases, please read below for any possible workarounds:

From R12.1 to R13, the behavior of the Real-Time Workshop regarding user *.c files in the build directory was changed. Previously any *.c files the user had put in the build directory were not deleted, but now they are, unless the string 'target specific file' is placed in the first line of the *.c or *.h file.

This is explained in the help for the R13 back-end file MATLAB_ROOT/toolbox/rtw/rtw/tlc_c.m.

 This function is responsible for managing the creation of the *.c and *.h files in the Real-Time Workshop build directory. It will also remove old *.c and *.h  files.  
 The normal operation of the Real-Time Workshop assumes that all *.c   
 and *.h files within the Real-Time Workshop build directory are created during the TLC process of the Real-Time Workshop build procedure. Third-party targets may also create *.c and *.h files in the build directory. To prevent the Real-Time Workshop from deleting or altering these files, the must be explicitly marked as target specific files by the presence of the string 'target specific file' in the first line of the *.c or *.h file.

You can read the complete file by typing "edit tlc_c.m" at the MATLAB command prompt.

Best Answer

Related Solutions

MATLAB: Is the Control System Toolbox 7.1 (R2006b) compatible with Real-Time Workshop 6.5 (R2006b)

MATLAB: Is the documentation on deletion of user *.c files from the ‘rtw’ build directory unclear in the Real-Time Workshop 5.0 (R13)

Related Question