MATLAB: Is the Xilinx Platform Cable USB II supported for FIL simulation

cabledigilentfilHDL Verifierplatformusbxilinx

I am using the USB-JTAG interface when trying to perform an FPGA-in-the-loop (FIL) simulation, but have not been able to connect to the board. The error I am getting is:
Did not find any Digilent(R) JTAG cable. Make sure that the cable is connected to your computer.
Failed to initialize the RTIOStream library.
The cable I am using is a Xilinx Platform Cable USB II, and the FPGA board has as Digilent chip for the USB-JTAG interface.

Best Answer

The Xilinx Platform Cable USB II is not supported for FIL simulation.
For FIL simulation, please use the Digilent JTAG-HS2 or JTAG-HS3 programming cables:
https://store.digilentinc.com/jtag-hs3-programming-cable/
https://store.digilentinc.com/jtag-hs2-programming-cable/
For more information on supported connections and cables, please refer to the 'Board Connections' section in the following document:
https://www.mathworks.com/help/supportpkg/xilinxfpgaboards/ug/supported-eda-tools-and-hardware.html#bvqjc88
Related Question