I am using a MUX to vectorize different signals in my model for xPC Target 4.2 (R2009b). I want to use this signals in a simulation on my host computer and therefore I am using the "from xPC" block. But with this block it seems that it only extracts the first value of the vector signal.
MATLAB: How to use data from a MUX block with the from xPC block in xPC Target 4.2 (R2009b)
frommatrixsignalsSimulink Real-Timetargetxpc
Related Question
- How to name and display mux signals read on a real-time target scope
- Can I not close an xPC Host Scope Viewer Figure saved as .fig file when opened later with xPC Target 4.2 (R2009b)
- Do I receive the error “Invalid Signal” when using “getsignal” from Simulink Real Time? The signal is listed with the target properties
- How are CPU Overloads managed in xPC Target 4.2 (R2009b)
- Do I get an EPROBFAILURE error while booting Target PC using xPC Target 4.4 (R2010b)
- Is it possible to use the Digital I/O lines for PWM generation in a board that is supported by xPC Target 4.2 (R2009b)
- How to store a bus signal to the MATLAB workspace while retaining its hierarchy in Simulink 7.6 (R2010b)
- How to read in a very large DAT file from xPC Target when I keep running out of memory using READXPCFILE in xPC Target 4.2 (R2009b)
Best Answer