MATLAB: .fig won’t open

cannot open figurevisible on

I have created a.fig file which is set to 'visible' however when I try and open this either using File >Open or openfig it is not seen. All suggestions I have found on the web suggest setting it to 'visible'. Can anyone help?

Best Answer

for your a.fig, do you have a.m file available with you? if yes, then you can run that .m file and or call that .m file wherever you want, then that fig file (GUI) will open..

If you want to edit that .fig file, then use ' guide' command.

Run guide command then go to tab for ' open existing GUI' browse your .fig file and the edit it..

Related Solutions

MATLAB: Confused: GUI / figure /

The reason why the third attempt doesn't find the GUI is that GUIDE GUIs have their figure handle visibility set to 'callback' so it is not seen except by its callbacks (and FINDALL). You can change this by:

set(gui,'handlevisib','on')
get(0,'currentfig') % Now it shows up!

MATLAB: Emailing gui code

You need to send unit5.fig as well.

GUIDE generates two files: a .m file and a .fig file. Neither part is meaningful without the other.

There is an option in GUIDE to generate pure .m code that builds the figures and controls at run time. That would result in a single (larger) .m file that could be emailed.

Best Answer

Related Solutions

MATLAB: Confused: GUI / figure /

MATLAB: Emailing gui code

Related Question