I am using ActiveX Control blocks to place dials and gauges in a subsystem. However, when I try to feed the output of the Dials and Gauges blocks to the top-level of my Simulink model where the ActiveX Control blocks are located, I do not see an output on the Scopes.
MATLAB: Am I unable to see the output from a Dials and Gauges 1.1.3 (R13SP1) block in the top-level of the Simulink model when using ActiveX Controls
activexandcontroldialsgaugesGauges Blocksetoutputsubsystem
Related Question
- Is there any additional help available for the Dials and Gauges Blockset 1.1.3 (R13SP1)
- Am I unable to save changes to the Simulink 5.0 (R13) model which contains Dials & Gauges 1.1.2 (R13) blocks
- Do all the Dials and Gauges blocks in a subsystem all look the same in R12.1 and R13 after installation
- Am I unable to properly display and use blocks from the Gauges Blockset 2.0 (R14SP1)
- How to get the Program ID for a block from Dials and Gauges Blockset 1.1.3 (R13SP1) so that I can use it as an ActiveX object
- Does the active area of the Dials and Gauges 1.1.2 (R13) block disappear if click outside the block
- How to use the alphanumeric display on the IRIG Format block in the Gauges Blockset 2.0 (R14SP1)
- Do I receive a segmentation violation when I right-click on a Strip Chart in the Dials and Gauges Blockset 1.1.3 (R13SP1)
Best Answer