I'm planning to use the classicthesis package for typesetting my PhD, however the university regulations dictate that it must be printed one-sided. Is there a way of configuring classicthesis, such that the left margin is always the inner and the right margin the outer? The default behaviour of alternating inner and outer margins looks very odd when printed single-sided.
[Tex/LaTex] Classicthesis formatting for one-sided printing
classicthesismargins
Related Solutions
If you define inner and outer margins instead of left/right or even/odd and use the attributes of the documentclass to switch between oneside and twoside it will be all right. The example below works for me just fine.
\documentclass[oneside]{book}%
\usepackage{geometry}
\usepackage{lipsum}
\newgeometry{
top=1in,
bottom=1in,
outer=1in,
inner=2in,
}
\begin{document}
\lipsum[1-20]
\end{document}
When setting margins for two-sided documents, the deciding question is how a left and a right page look next to each other, not how they look on their own. The right margin of the left page and the left margin of the right page become a single gap between the two type areas here, essentially a "center margin". In chapter 2 of the KOMA-script manual, this is illustrated with the following figure.
Now, opinions on good design differ and special cases may require exotic type area settings. However, there are established conventions that have been used by professionals for a long time1 and I think it is best to take those as a starting point. The principles laid out in the KOMA-Script manual are:
- The type area has the same proportions as the page.
- Left, right and center margin have the same width.
- The bottom margin is twice as high as the top margin.
In the image above, this is achieved by dividing the width and height of each page into 9 equal columns/rows. This corresponds to the KOMA option DIV=9. With the geometry package no automatic calculations like this are available, but you can of course calculate the values yourself (or look them up somewhere).
1Of course, there is good and bad typography among professionals as well. I have seen quite some textbooks where the publisher obviously was concerned more with saving space (i.e. money) than with a pleasant layout. (In some cases this is justified. I don't read a lexicon cover to cover, so it does not have to be easy to do so.) However, in most novels for example, you will find a layout adhering to the principles described here. Pick up some books from your shelf and compare.
Ok, so this is why the outer margins of pages in two-sided documents are wider than the inner margins. What about binding?
As you stated, some of the width of your page will be lost to binding, depending on how you do it. This means that the page (which I talked about above) is somewhat smaller than the paper. Since the amount lost is not visible after binding, it does not count to the margins but is a separate value.
- In KOMA-Script, the option
BCORsets the width lost to binding from both papers together. That is, when you setBCOR=1cmeach page is 0.5 cm narrower than the paper. (This is the width of the light gray area in the image above.) - With the
geometrypackage, the optionbindingoffsetsets the width lost to binding from every paper. That is, when you setbindingoffset=1cmeach page is 1 cm narrower than the paper.
You can set only these values if you want to keep the default layout of your class but additionally account for binding.
Which value should you use? Ask the person binding it for you. If they don't know, the loss is probably small enough that a BCOR value of 0.5 cm (or a bindingoffset of half that) will be enough. Have a look at samples, if you can. See also this answer.
Best Answer
Is this really related to the
classicthesispackage? It should depend on the document class you use. Try to add the optiononesideto your document class command.