I have a bus creator in my model that is behaving weirdly, or at least I have never seen this before and I have no idea how to fix this (I've tried several things to no avail, first of all replacing the bus creator with a fresh one from the library browser to make sure nobody messed with the properties). I am getting the following error message(s) when trying to run the model:
Simulink cannot unify the dimensions of the multiplexed signal at output port 1 of '[…]/HMI Spec/Bus Creator' to match the input dimension of input port 1 of '[…]/HMI Spec/Out1'. Specifically, Simulink cannot unify {1,1,1,1,1,1,1} to match 1. Consequently, Simulink cannot propagate dimension information from output port 1 of '[…]/HMI Spec/Bus Creator' to input port 1 of '[…]/HMI Spec/Out1'.
Component:Simulink | Category:Modelerror
Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of '[…]/HMI Spec/Bus Creator'.
Component:Simulink | Category:Modelerror
Error in port widths or dimensions. Input port 1 of '[…]/HMI Spec/Out1' is a one dimensional vector with 1 elements.
In the model it looks like this:
Inside the submodels there's a structure like this (they all look the same):
As you can see, these are all 1-dimensional signals. They initially come from a dSpace RTICAN-Block, but this has never been a problem before, as they're all just doubles. I have no idea why this single bus creator is acting up like this. Any ideas or input is greatly appreciated!
Best Answer