MATLAB: Target monitor didn’t displays information about the Ethernet cards

information about ethernet cardsintel i211-at gbe;Simulink Real-Time

I have a target computer which should be supportet by simulink Real-Time.
JBC420U591W-3160-B incl. 64GB mSATA Storage, 4GB RAM.
I use Matlab 2016b, Simulink Real-Time 6.5
Simulink Real-Time Target Settings
    Name                     : TargetPC1                     
    TargetRAMSizeMB          : Auto                          
    MaxModelSize             : 1MB                           
    SecondaryIDE             : on                            
    MulticoreSupport         : on                            
    LegacyMultiCoreConfig    : on                            
    USBSupport               : off                           
    ShowHardware             : on                            
    EthernetIndex            : 0                             
    TcpIpTargetAddress       : 192.168.0.10                  
    TcpIpTargetPort          : 22222                         
    TcpIpSubNetMask          : 255.255.255.0                 
    TcpIpGateway             : 192.168.0.1                   
    TcpIpTargetDriver        : Auto                          
    TcpIpTargetBusType       : PCI                           
    TargetScope              : Disabled                      
    TargetBoot               : BootFloppy                    
    BootFloppyLocation       : E:\
Because this computer has 2 "Intel i211-AT GbE" Ethernet cards, I did following steps. Ethernet Card Selection by Index
But then there shows up now Information about Ethernet cards. Additionally I get the Error: No accessible disk found: file system disabled
I can solve this Error by enable USB Support, but then I get the error. Unexpected Interrupt (APIC Mode) CPU Exception: 0008 Error code: 000e heap
And also no Information about EthernetCards.

Best Answer

Solved with Matlab 2017a and Simulink Real-Time 6.6
Related Question