MATLAB: Simulink PIL blocks.

Question

Can we use two or more PIL blocks (created for c6713 by CCS v3.3 from marlab R2011a) in one simulink model ???

I converted all the subsystems of my model into indivisual PIL blocks and connected with each other to form my complete model. But when I run the model it stucks at the 1st PIL block.

It is saying "U have a break point"… "Remove the break point & run".

why it is happening ???

Answer 1

I highly doubt that multiple PIL blocks are supported in one model. I would recommend confirming this with MathWorks Tech Support and submit an enhancement request with details about your usecase/requirements so that the developers of that team may consider this as an enhancement for a future release.