Hello,i am trying to communicate with a "reciever" device which is connected as shown in the attached photo(serial-com).
i communicated with the device using PCOM software,as shown in the attached photo with "hexadeximal" commands.
i tried to do the same thing with matlab shown as following,
but it doesnt do anything,how to do these hexadecimal commands in matlab?
Thanks
s = serial('COM4');set(s,'BaudRate',115200);fopen(s);fprintf(s,'0801')fprintf(s,'63')out = fscanf(s);fclose(s)delete(s)clear s
Best Answer