I am trying to use an Arduino Nano 3.0 with MATLAB. I get the following error from trace:
System wide configuration file is "C:\ProgramData\MATLAB\SupportPackages\R2019b\3P.instrset\arduinoide.instrset\hardware\tools\avr/etc/avrdude.conf" Using Port : COM5 Using Programmer : arduino Overriding Baud Rate : 115200avrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x7eavrdude: stk500_recv(): programmer is not respondingavrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x7eavrdude done. Thank you.An error occurred while uploading the sketch
I can however, use the Arduino IDE to upload code and get serial info. Note that the Nano is probably a clone and shows as FTDI USB Serial in the COM port.
Best Answer