MATLAB: Parsim Rapid Accelerator Mode setting Start Time and Stop Time

Parallel Computing Toolboxparsim rapid accelerator mode start/stop timesimulink

I would like to set the start time and stop time of Parsim. I have followed https://www.mathworks.com/help/simulink/slref/rapid-accelerator-simulations-using-parsim.html

to setup the simulation but I cant figure out how to change the start and stop time of the simulation. I have tried setting start and stop times to variables and using .setvariable with no luck. Any help would be great.

Best Answer

Hi Betsy,

You can set StartTime and StopTime as ModelParameters on the SimulationInput object

in = in.setModelParameter('StartTime','1','StopTime','4');

Related Solutions

MATLAB: Is there a TimeOut option with parsim

It is possible to set the TimeOut option with 'parsim' as well. To do so, you would have to define a Simulink.SimulationInput object first, and then set the TimeOut option through this object.

Any option set with 'sim' and any common model parameters can be defined through the Simulink.SimulationInput object.

Below is an example that shows how to do this using the 'vdp' model:

vdp                                          % Open model vdp
in = Simulink.SimulationInput('vdp')
in = in.setModelParameter('TimeOut', 5)      % Set time out to 5 sec
in = in.setModelParameter('StopTime', 'inf') % Set total simulation time to infinity
out = parsim(in)

MATLAB: Parsim in parfor loop

Hi,

parfor-loop+sim = parsim to run simulink simulations in parallel.You cannot use a parfor-loop inside another parfor-loop. For more information you may check this link1 and link2.

Hope this helps.

Best Answer

Related Solutions

MATLAB: Is there a TimeOut option with parsim

MATLAB: Parsim in parfor loop

Related Question