I have a National Instruments 6353 Data Acquisition (DAQ) box. I have an external trigger operating at 10 Hz, so 0.1 seconds per pulse.
When a trigger occurs, I wish to measure 0.05 seconds of the pulse and send the data from analogue input channels to the computer for processing. I want this to occur until I give the stop command.
Ideally, I wish there was a listener that listened for triggers, and when a trigger occurs, it collects the data, sends it to the PC and notifies that the data is ready.
I have spent a lot of time going through the documentation but have still not found the solution. I understand that this is trivial to setup in Labview, but I want to achieve this in Matlab 32 bit.
Any help/examples will be much appreciated.
Best Answer