I am new to the simscape library so I am unsure how to properly simulate physical models. I am trying to measure the current across the "solar cell" block in simscape under standard conditions. I have linked the solar cell block to a current sensor then back to the solar cell block, linking the sensor to a PS-S converter then a scope. I have included a solver configuration block, as required from what I can gather, and set it to ode15s. When I run the simulation, however, I get nothing read out on the scope. I tried adding a resistor as a load to measure the current across that but to no avail – the current reading is still 0 on the scope.
I'm not sure how to proceed,can anyone help me to see the error of my ways? I would be happy to supply the simulink model if needed.
Best Answer