I want to use the data logging and tuning function provided by the CAN Calibration Protocol block in Target Support Package TC2. To setup the CAN interface between the host computer and embedded system, a CAN interface card on the host computer is required. Is there any recommended hardware?
MATLAB: Is there any recommended CAN interface card with CAN Calibration Protocol block in Target Support Package TC2 3.2 (R2009a)
canccphardwareinterfaceTarget Support Package TC2
Related Question
- How to use the pack and unpack functionality with SCI transmit and receive blocks in Target Support Package TC2 3.1 (R2008b)
- How to set up “Emulation Mode Bits” for the TC2 ePWM block in Target Support Package TC2 3.1 (R2008b)
- Does the Embedded Target for TI C6000 DSP 1.0 (R13) support code generation for the C28x DSP family
- Is Fixed Point Toolbox a requirement for Target Support Package TC2 even with a floating point digital signal controller
- Do the embedded target products (Target for TI C2000 and Target for TI C6000) work with third party emulators
- Is there ‘Multiply by -1’ operation in demo models under Target Support Package TC2 (R2008a)
- Am I unable to run the demo “Video Surveillance Recording” under the “Target Support Package: TC6” Demos in Simulink 7.1
Best Answer