MATLAB: Is Hardware-in-the-Loop (HIL) optimization supported when using the Link for Code Composer Studio 1.3.1 (R14) with the TI C6x or C54x DSK

Embedded IDE Link CChardwarehardware-in-the-loophilloop

When I compile using the Link for Code Composer Studio, I receive an error similar to one of the following:
 Warning: Not enough information is available to locate and extract the function declaration. Use DECLARE to supply function declaration. 
 Warning: The C declaration of the function 'setstruct' cannot be located. Use DECLARE to supply this information.
 Warning: A problem occurred while parsing the function declaration:
   'struct funstruct setstruct(int a, char b, double c)'
   Error is: GetDatatype: Line position not found.funstruct' cannot be defined.
 Use DECLARE to enter the correct function declaration string.
 ??? Error using ==> function/write/CheckInputvarIfValid
 'a' is not an input argument to 'setstruct'.
or
 Warning: A problem occurred while parsing the function declaration:        
   'struct funstruct setstruct(int a, char b, double c)'                   
   Error is: GetDatatype: Line position not found.funstruct' cannot be      
 defined.                                                                   
 Use DECLARE to enter the correct function declaration string.              
 ??? Error using ==> function/write/CheckInputvarIfValid                    
 'a' is not an input argument to 'setstruct'.

Best Answer

Link for Code Composer Studio 1.3.1 (R14) does not support the following options for HIL compiling:
For the TI C6x DSK:
"DWARF Debug Info."
For options of "opt. speed vs. size":
1- "Speed more critical"
2- "Speed critical"
3- "size critical"
4- "size most critical"
Instead, it only supports the default "speed most critical" for HIL compiling.
For the TI C54x DSK:
"No Debug"
"DWARF Debug Info"
Any optimization options other than "none." "none" is the only supported optimization.
Related Question