how to read the data base of the imageno_attemptno_details
how to read 100 images at a time ? what will appear on the output? how to analyzed the output?
Best Answer
Ganesh,
If you are trying to observe the change in each parameter over time (i.e. from image 1 to image 100), just use a for loop around the load/calculate/release for each image and dump the desired parameters into an output array. for example:
for imagecount=1:100
(code:load/calculate/release image)
output(:,i)=[mean stdev];
end
You can then plot or otherwise analyze the trends in mean/stdev.
If you want to get the mean/stdev of the whole datacube, then use a for loop the genereate the entire cube.
This requires that you know what the signal is and what the noise is. Note, you can't simply say the signal to noise ratio is the ratio of the mean of the image to the standard deviation of the image like many novices think. If you want the average SNR over all pixels, use mean():
Best Answer