When using a Configurable Subsystem block to switch between library blocks I see the Configurable Subsystem does a nice job of representing the mask properties in the chosen block. However, Block Annotation is not showing up. Is there a way to flow up the Block Annotation properties? Normally I am showing parameter values below the blocks by using Block Annotation but this doesn’t work if I wrap the blocks in a Configurable Subsystem.
MATLAB: How to flow Block Annotation settings through a Configurable Subsystem
block annotationconfigurable subsystemmaskpicturessimulink
Related Question
- How can one get Block Choices for a Configurable Subsystem in an array by using Matlab Command
- How to change the annotations of a block in Simulink to reflect the value of the parameter variable from the workspace
- How to set/get the data type of a constant block on Simulink
- Simulink Pass Variable to Mask Parameter
Best Answer