MATLAB: How can i run a simulink model for given simulation time

MATLABsimulinkstateflow

I have a simulink model which i am controlling from Matlab engine in C++ application. i start the simulation by using command set_param("mySimulinkModel","SimulationCommand","start"). now my requirement is the run the simulink model only for given simulation time (timeStep), once the simulation exceed the given simulation time step it should be paused.

how can i setup my model to run it only for given simulation time step?

Best Answer

Bhawesh, you mean, you would like to set the simulation stop time? This is done using

set_param('mySimulinkModel','StartTime','5','StopTime','100')

showing also start time set up. For a complete list of model parameters check out the documentation.

Related Solutions

MATLAB: Simulation control in m-file

set_param('ModelName', 'SimulationCommand', 'start')
set_param('ModelName', 'SimulationCommand', 'stop')
set_param('ModelName', 'SimulationCommand', 'pause') <- Pause simulation
set_param('ModelName', 'SimulationCommand', 'continue')
set_param('ModelName', 'SimulationCommand', 'update')

MATLAB: Reset Simulink model from m file

Using set_param(model, 'SimulationCommand', 'stop') followed by set_param(model, 'SimulationCommand', 'start') does restart the model from t=0. You need to use set_param(model, 'SimulationCommand', 'pause') followed by set_param(model, 'SimulationCommand', 'start') to continue where the model was paused.

Best Answer

Related Solutions

MATLAB: Simulation control in m-file

MATLAB: Reset Simulink model from m file

Related Question