The orifice equation used in the fixed area-orifice block can only result in flowrate from the two inputs, PA and PB, and parameters: Area, Cd, fluid density & kinematic viscosity, and Reynolds number. How is Simscape able to obtain both pressure and flow rate at the hydraulic ports with just one equation?
MATLAB: How are the pressure and flow rate calculated for a fixed-area orifice in SimHydraulics 1.4 (R2008b)
Simscape Fluids
Related Question
- How to model flow rate caused by a decreasing volume as in a piston with SimHydraulics 1.1 (R2006b)
- How to specify an initial condition for pressure for the Single-Acting Hydraulic Cylinder in SimHydraulics 1.4 (R2008b)
- Simscape Hydraulics mass flow rate vs pressure drop
- Flow rate control
- How to parameterize hydraulic valve with given manufacturer data sheet current vs flow rate
- Does the position of a Double Acting Hydraulic Cylinder exceed the piston stroke’s limits in SimHydraulics
Best Answer