MATLAB: Generating square wave using an embeded matlab function

embedded matlab functionsimulationsimulinksimulink codersquare wave

Hi,
I intend to generate a square wave which is applied on a DSP.
I have written these codes and put them in an embeded Matlab function.
function y = fcn(u)
%#eml
t=0:0.001:1
h = sign(sin(125600*t+u));
y= (h+1)/2
where, u is a constant value of 0.582 which is used for shifting the square wave.
The problem is at the out put in the simulation, instead of getting a square wave, I see only two straight lines of y=o and y=1.
Please let me know where is the problem that I can not get the square wave?
Note that the frequency of square wave must be 20 kHz. Therefore, I adjust the sampling time as 1e-7 s. And also its amplitude is between 0 and 1 In addition, due to this signal must be transferred to a DSP board, in the "solver option" I chose the type: " Fixed-step" and for the Solver: "Discrete (no continues state)".
Thanks a lot.

Best Answer

Your function is fine. You are not zoomed in enough to see the wave transitions.
Related Question