If you build a real circuit with two switches connected in series as in your example "Basic_network_topology.mdl", the voltage appearing across switches when both switches are opened will be dictated by the stray capacitance of each individual switch and by their capacitances to ground. We can assume that the resistive leakage current is negligible.
For a mechanical switch this stray capacitance can be evaluated based on the
switch geometry or it can be measured.
In your example, if you replace the resistive snubber by capacitive snubbers
by setting
(assuming 10 pF stray capacitances), you will still obtain 50 V across each switch. See example model "Basic_network_topologyGS.mdl".
Now, if the capacitances are
Cs1= 10 pF and Cs2=30 pF
you get
Vsw1= 75 V and Vsw2 = 25 V.
Naturally, if you use a Voltage sensor with given input impedance, the voltage sharing will be affected. For example, using a voltage sensor with 10-Megohm resistive input impedance to measure Vsw1 and Cs1=Cs2= 10 pF will give
If the voltage source is an AC source of 60 Hz and 100V peak voltage, you would get Vsw1 = 3.8 V peak and Vsw2 = 99.8 V .
In other words, the voltage sharing is highly dependant on the stray capacitances and voltage sensors input impedances as it would be in the real life.
Best Answer