Hello All,
I am using Raspberry Pi 3B. I need to use a different wifi connection in my raspberry pi hardware. Is there any option to change it through matlab or I need to reinstall the support package?
MATLAB: Changing Wifi connection in Raspberry Pi 3 B
MATLAB and Simulink Student Suiteraspberry pİ 3 b
Related Solutions
I solved it :) So it turns out I need to set a configuration on Matlab beforehand to link all the external libraries together.
this is my set param example:
set_param('wifi_template','CustomSource','./SPI.cpp ./WiFi.cpp ./WiFiClient.cpp ./WiFiMDNSResponder.cpp ./WiFiServer.cpp ./WiFiSSLClient.cpp ./WiFiUdp.cpp ./bsp/source/nm_bsp_arduino.c ./bsp/source/nm_bsp_arduino_avr.c ./common/source/nm_common.c ./driver/source/m2m_ate_mode.c ./driver/source/m2m_crypto.c ./driver/source/m2m_hif.c ./driver/source/m2m_ota.c ./driver/source/m2m_periph.c ./driver/source/m2m_ssl.c ./driver/source/m2m_wifi.c ./driver/source/nmasic.c ./driver/source/nmbus.c ./driver/source/nmdrv.c ./driver/source/nmi2c.c ./driver/source/nmspi.c ./driver/source/nmuart.c ./socket/source/socket.c ./socket/source/socket_buffer.c ./bus_wrapper/source/nm_bus_wrapper_samd21.cpp ./spi_flash/source/spi_flash.c')First, confirm that the router/network can accept and allow requests to assign static IP address.
It is possible that the MKR WiFi 1010 board has an older WiFi NINA firmware (versions before 1.2.0) which is causing this issue. Update the WiFi NINA firmware on the board to a version 1.2.0 or higher.
Detailed instructions to update firmware:
1) Download ‘WiFi101-Updater-ArduinoIDE-Plugin-0.10.7.zip’ from the following link and extract the file
2) Type the following command in MATLAB Command Window:
>> arduinoio.IDERoot
3) Outside of MATLAB, go to the location output from Step 2 and navigate inside the folder titled ‘tools’
4) In this new location, copy and paste the WiFi101 folder from the extracted zip file (Step 1) to replace existing folder
Example new path: C:\ProgramData\MATLAB\SupportPackages\R2019a\3P.instrset\arduinoide.instrset\arduino-1.8.1\tools\WiFi101
5) Go back to the location output from Step 2 and open Arduino application
6) Confirm the board (Tools > Board) and port number (Tools > Port) matches that of your MKR WiFi 1010 board
7) Go to Examples > WiFiNINA > Tools > FirmwareUpdater
8) Upload this sketch to your Arduino MKR WiFi 1010
9) After you get the “Done uploading.” message as shown below, click on Tools > WiFi101/WiFiNINA Firmware Updater
10) Select the port that matches your MKR WiFi 1010 board and confirm that the firmware pre-selected is NINA firmware (1.2.0 or higher) and then click Update Firmware
11) You should get ‘The firmware has been updated!’ confirmation message as shown below
12) Close Arduino IDE; go to MATLAB and try setting your Static IP address.
Now, the Device Address will match the IP address provided.
Best Answer