MATLAB: Change the simulation stop time from a block

block propertysimulinkstop time

I understand you may change the simulation stop time using set-param function. However, I'd like to do the same thing with a block. This way I can make it to a library so that people just take it from library and drop to his/her model. I need to be able to change the stop time which is calcuated by this block. Thanks.

Best Answer

You can stop the simulation at any using stop block: https://www.mathworks.com/help/simulink/slref/stopsimulation.html. You can define a condition, and when the condition becomes true, the simulation stops. Note, this method will only allow decreasing the simulation time. If you want to run the simulation, longer than the stop-time, I am not sure whether it is possible.

Related Solutions

MATLAB: Set Simulink model simulation stop time from m file

You can set_param for the model also:

   set_param('modelname', 'StopTime', '3000')

MATLAB: I am using the test manager to run the tests in a model. In the Test Sequence editor I make a call to the following code as the last step. coder.extrinsic(‘bdroot’); coder.extrinsic(‘set_param’); set_param(bdroot, ‘SimulationCommand’, ‘stop’);

You must have an output of the Test Sequence block to a Stop Simulation block and have the Test Sequence block change the output to true when you want the simulation to stop.

Here are some steps:

1. Initialize a output variable to false in the Test Sequence block

2. In your proposed step in the Test Sequence block, change this output variable to true.

3. Connect this output to the Stop Simulation block, so that the Simulation is stopped by the Stop Simulation block.

Best Answer

Related Solutions

MATLAB: Set Simulink model simulation stop time from m file

MATLAB: I am using the test manager to run the tests in a model. In the Test Sequence editor I make a call to the following code as the last step. coder.extr​insic(‘bdr​oot’); coder.extr​insic(‘set​_param’); set_param(bdroot, ‘SimulationCommand’, ‘stop’);

Related Question

MATLAB: I am using the test manager to run the tests in a model. In the Test Sequence editor I make a call to the following code as the last step. coder.extrinsic(‘bdroot’); coder.extrinsic(‘set_param’); set_param(bdroot, ‘SimulationCommand’, ‘stop’);