As I want to Measure Pressure drop in Pipe considering Parameters like compressibility so for that can I use Pipe(TL) as segmented/discretised models so I can compare pressure drop in segmented pipe.
MATLAB: Can Pipe(TL) is used with Pneumatics
pipe(tl)pressure dropsimulink
Related Solutions
The Laminar pressure ratio is the ratio between the downstream pressure and the upstream pressure. When this ratio is reached, it will transition to a laminar regime.
There are two blocks in the Pneumatic Foundation library that allow you to add heat to the system. These are the Constant Volume Pneumatic Chamber and the Pneumatic Piston Chamber blocks. Both blocks have a thermal port, labeled H, which can connect to Thermal domain blocks.
If the heat is added to a variable volume of gas in an actuator, then you should use the Pneumatic Piston Chamber block. If the heat is added to a constant volume, e.g., a pipe, you should use the Constant Volume Pneumatic Chamber.
For the latter case, a pneumatic pipe can generally be modeled using the construct in the image below. It's very common to do this.
- Sebastian
Related Question
- Pneumatic chamber
- Does ‘T’ have the same value as ‘Tb’ in the Pipe (TL) block in Simscape
- Is the specific internal energy of the Simscape two phase fluid model discontinuous
- Is there a pipe bend or elbow bock for thermal fluid
- How are the hydraulic fluid properties determined based on the line pressure in SimHydraulics
- Pneumatic/​Hydraulic/​Thermal Liquid domain – flow discharge coefficient vs. flow coefficient
Best Answer