MATLAB: Arduino to Matlab Real time plotting

arduinoarduino to matlabreal time

hi, im an engineering student and also new to MATLAB. Actually im having problem to plot the data from arduino in real time. For testing purpose im using arduino AnalogSerialInOut coding.
/*
  Analog input, analog output, serial output
 Reads an analog input pin, maps the result to a range from 0 to 255
 and uses the result to set the pulsewidth modulation (PWM) of an output pin.
 Also prints the results to the serial monitor.
 The circuit:
 * potentiometer connected to analog pin 0.
   Center pin of the potentiometer goes to the analog pin.
   side pins of the potentiometer go to +5V and ground
 * LED connected from digital pin 9 to ground
 created 29 Dec. 2008
 Modified 4 Sep 2010
 by Tom Igoe
 This example code is in the public domain.
 */
// These constants won't change.  They're used to give names
// to the pins used:
const int analogInPin = A0;  // Analog input pin that the potentiometer is attached to
const int analogOutPin = 9; // Analog output pin that the LED is attached to
int sensorValue = 0;        // value read from the pot
int outputValue = 0;        // value output to the PWM (analog out)
void setup() {
  // initialize serial communications at 9600 bps:
  Serial.begin(9600); 
}
void loop() {
// read the analog in value:
sensorValue = analogRead(analogInPin);            
// map it to the range of the analog out:
outputValue = map(sensorValue, 0, 1023, 0, 255);  
// change the analog out value:
analogWrite(analogOutPin, outputValue);           
// print the results to the serial monitor:
Serial.print("sensor = " );                       
Serial.print(sensorValue);      
Serial.print("\t output = ");      
Serial.println(outputValue);   
// wait 10 milliseconds before the next loop
// for the analog-to-digital converter to settle
// after the last reading:
delay(10);                     
}
Anyone please can help me?

Best Answer

Yea its a sample coding from arduino but i need to replace the potentiometer with the microphone. so 1st i want to test the variables from the potentiometer in the real time graph. so anyone can help me with the simple coding
Related Question