MATLAB: Am I unable to display all of the signals in the model using the Web browser interface in xPC Target 2.6.1 (R14SP1)

browserinterfacelargenumberscopesignalSimulink Real-Timetargetwebxpc

I connect the target application on the target PC to the xPC Target Web browser interface on the host PC. When selecting a signal and then clicking the "Apply" button, the remaining signals are listed sequentially on the same line, i.e., without carriage returns, and the following error message is displayed:

 Your browser does not support the redirect HTTP code.  Follow this link <underlined> to go to the requested page.

I encounter similar behavior when adding signals to a Scope using the xPC Target Web browser interface.

Best Answer

This bug has been fixed in Release 14 Service Pack 3 (R14SP3). For previous product releases, read below for any possible workarounds:

We have verified that there is a bug in xPC Target 2.6.1 (R14SP1) in the way that the Web browser interface handles numerous signals. Consequently, the Web browser interface is unable to properly display a large number of signals.

There are currently no known workarounds.

Related Solutions

MATLAB: Is the first letter of the signal name truncated when displayed on a Target Scope in xPC Target 2.7.2 (R14SP2)

This bug has been fixed in Release 14 Service Pack 3 (R14SP3). For previous product releases, read below for any possible workarounds:

We have verified that there is a bug in xPC Target 2.7.2 (R14SP2) and earlier when using signal names with xPC Target Scope blocks.

To work around this issue, prepend an underscore ('_') to the input signal names for xPC Target Scope blocks in Simulink. For example, if your signal name is "mysignal", change it to "_mysignal" to correctly display the signal on your target PC.

MATLAB: Is there a demo model in xPC Target 2.7.2(R14SP2) that demonstrates reading and writing to VMICPCI-5565 shared memory on the target machine

This enhancement has been incorporated in Release 2006b (R2006b). For previous product releases, read below for any possible workarounds:

The documentation of xPC Target 2.7.2 (R14SP2) does not contain a demo model that describes how to read and write to the VMICPCI-5565 shared memory.

You can use the attached model file (VMIC5565demo.mdl) as an example of how to read and write to the VMICPCI-5565 shared memory. This model uses the default partitions as follows:

node=completenodestruct([],'5565');
part = completepartitionstruct([],'5565');

The first target scope displays the written value and the second target scope displays the status of the VMIC board LISR register.

Best Answer

Related Solutions

MATLAB: Is the first letter of the signal name truncated when displayed on a Target Scope in xPC Target 2.7.2 (R14SP2)

MATLAB: Is there a demo model in xPC Target 2.7.2(R14SP2) that demonstrates reading and writing to VMICPCI-5565 shared memory on the target machine

Related Question