[GIS] QGIS Error when clipping a raster with a shape layer

qgisqgis-2

I am trying to clip a .tif file using the extent of a polygon (.shp). I am using the conventional Raster/Extraction/Clipper tool in QGIS 2.18.10. After choosing the appropriate settings, I get the following message:

ERROR 1: Attempt to create ADRG dataset with an illegal data type (Float32), only Byte supported by the format.

I am asking the exact same question as uybfi in this thread, which was marked as a duplicate for no apparent reason. The referred answer fails to address the issue. My raster is already in a supported format (Float32), and when changing the pixel depth with gdal_translate to other supported formats (e.g. Int32), I still get the this error.

Any thoughts?

Best Answer

The issue had to do with QGIS wrongfully inputing -of ADRG instead of -of GTiff in the command line when choosing the output file destination. Below is a screenshot of the clipper window properly set-up to successfully perform the clip operation. Thanks to @MichaelStimon for resolving this.

Related Solutions

[GIS] error message when clipping raster with vector layer

This error occurred because the raster and vector were not in the same projection. In this case, the vector layer had to be reprojected to match the raster CRS.

[GIS] Clipping raster layer with raster mask layer in QGIS

The simple way to do this in QGIS is to use the Raster Calculator (Raster->Raster Calculator). You have a couple of options. The easiest to explain/understand is to make a unitary raster from your mask (all data set to either 1 or NoData) and then multiply your clip layer by the unitary mask layer.

To ensure the extents match the mask layer, in the raster calculator window select the mask layer in the 'Raster bands' list on the left and then click the 'Current layer extent' button on the right.

You can create a unitary mask on the fly by using a conditional statement (see the link) something like this:

(maskLayer@1 >= 0) * clipLayer@1

This statement basically says: treat everything in my mask layer that is not NoData as being equal to 1 (NoData stays as NoData). Just be sure to remember to set the extent (see above)!

Raster Calculator and paletted data:

Any output from the raster calculator will be just values and not carry over any information contained within a colour pallet. You have a couple of options to 'get your palette back':

Go to the style tab of the original layer's properties and (making sure it is paletted), click on Save Style button at the bottom. You can then apply this same style to your new layer and if you have only clipped it as per the above instructions, it will appear the same as before. This is easy but your raster is not paletted in a persistent way outside of the QGIS project.
To make the presentation persistent, you can right-click the layer and 'Save As'. Check the 'Rendered Image' radio button at the top of the save-dialog box. This will make a new raster with the exact colour scheme as your palatted layer BUT it will no longer be a single band raster but a four band RGBA raster.
If you MUST have an actual stand-alone single-band raster with a persistent palette (and not RGBA), then I don't know of a way of doing this in QGIS but you could take the output of step 2 above and open it in GIMP (or Photoshop) and change the mode from RGB to Indexed Colour. But you will need to create a world file as saving the image in GIMP/Photoshop will destroy the georeferencing.

Best Answer

Related Solutions

[GIS] error message when clipping raster with vector layer

[GIS] Clipping raster layer with *raster* mask layer in QGIS

Related Question

[GIS] Clipping raster layer with raster mask layer in QGIS