I'm new to GIS.
I have a shapefile for which I defined the coordinate system (using the Define Projection tool) to WGS_1984_UTM_Zone_32N and now
I'm trying to reproject the shapefile from WGS_1984_UTM_Zone_32N to GCS_WGS_1984.
I'm using the Project tool but I always get the following error and the projection never happens.
ERROR 999999: Error executing function
invalid extent for output coordinate system.
The operation was attempted on an empty geometry
I run the Repair Geometry tool ,it works fine, but then when I try to reproject to GCS_WGS_1984 I still get the same error as above
I don't understand what I'm doing wrong.
I know similar questions have been asked in the past but I couldn't find one where someone gets an error.
Best Answer
As commented by @wittich:
and @mkennedy: