I use TeXnicCenter Alpha, DDE control TeXnicCenter, MikteX 2.7, Adobe Reader 10, and Windows 7. Whenever I build, the log file reads "undefined !control sequence
" and whenever I output the file, the Adobe Reader will pop up, but the document is not shown, and when I close the Adobe Reader, then TeXnicCenter will not respond. How can I fix this?
[Tex/LaTex] An issue when using TeXnicCenter Alpha and Adobe Reader 10
miktexpdftextexniccenterviewers
Related Question
- [Tex/LaTex] TeXnicCenter & Adobe Acrobat 10
- [Tex/LaTex] MiKTeX / TeXnicCenter / Adobe Reader: No pdf produced
- [Tex/LaTex] TeXnicCenter & Adobe Reader DC
- [Tex/LaTex] How to correctly configure TeXnicCenter to open PDF files with the Microsoft Windows Reader app
- [Tex/LaTex] viewer command that will close only the current PDF document in TeXnicCenter
- [Tex/LaTex] TeXnicCenter & Adobe Reader DC in 2020
Best Answer
The DDE commands that control acrobat 10 changed compared to older versions. You can have a look here.
This document is written in German, but I think the figures are self explaining. From that document, Figure 25 shows the settings
Apparently it is also required to go in the acrobat settings and check a box "start savemode at start-up" (may be called slightly different) in the general settings tab.